1. Manuals
  2. Brands
  3. Aiwa Manuals
  4. Car Receiver
  5. CT-X432M
  6. Operating instructions manual

Aiwa CT-X432M Operating Instructions Manual

Stereo car cassette receiver
Hide thumbs Also See for CT-X432M:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Service Manual

OPERATING INSTRUCTIONS

MANUAL DE INSTRUCCIONES
MODE D'EMPLOI
CT-X432M
STEREO CAR CASSETTE RECEIVER
RADIO-CASSETTE ESTEREOFONICO PARA AUTOMOVIL
OWNER'S RECORD
For your convenience, record the model number and
serial number (you will find them on the bottom side of
your set) in the space provided below. Please refer to
them when you contact your AIWA dealer in case of
difficulty.
Model No. CT-X432M
Serial No.
YU
ENGLISH
ESPAÑOL
FRANÇAIS
8C-KTF-901-01
011130ATM-OX

Advertisement

Table of Contents
loading

Related Manuals for Aiwa CT-X432M

Summary of Contents for Aiwa CT-X432M

  • Page 1: Operating Instructions

    For your convenience, record the model number and serial number (you will find them on the bottom side of your set) in the space provided below. Please refer to them when you contact your AIWA dealer in case of difficulty. Model No. CT-X432M Serial No.

  • Page 2: Table Of Contents

    PRECAUTIONS • Use only in a 12-volt DC negative-ground electrical system. • Disconnect the vehicle’s negative battery terminal while mounting and connecting the unit. • When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating may cause serious damage to the unit.

  • Page 3: Theft Protection

    THEFT PROTECTION Take the front panel with you when leaving the car, and keep it in the supplied carrying case. Detaching the front panel Before detaching the front panel, remove the cassette to prevent possible damage to the unit. Press z to remove the cassette. Press and hold PWR/MUTE until the unit turns off.

  • Page 4: Radio Operation

    Adjusting sound You can select the following modes for adjusting sound depending on the music you listen to: BASS (low frequencies), TRE (high frequencies), BAL (left/right), FAD (front/rear) and H-BASS (high bass). Press SEL repeatedly to select the mode to be adjusted.
  • Page 5 Press BAND repeatedly to select the desired band (F1, F2, F3, A1, or A2). Press i (to move to higher frequencies) or k (to move to lower frequencies) to tune in to a station. “ST” appears in the display when an FM station is broadcasting in stereo, and receiving conditions are good.

  • Page 6: Tape Playback

    TAPE PLAYBACK Playing a tape Insert a cassette to start playback. If a cassette is already inserted, press SRC repeatedly to select Tape Play mode to start playback. Playback starts in the direction that the unit played back previously. Press the following buttons to operate tape transport. Press Eject a cassette* Change the playback side...

  • Page 7: Auxiliary Equipment

    (bright)” or “DIMMER 1 (dimmed).” CD CHANGER OPERATION Playing a CD You can play CDs from a connected AIWA CD Changer. For detailed information on installing a CD Changer, refer to the Installation and Connection manual supplied with the CD Changer.

  • Page 8: Troubleshooting

    The unit does not retrieve previous tracks during Random Play. ENGLISH TROUBLESHOOTING Error code (when using the optional AIWA CD Changer) In the following cases the corresponding error code indication appears. Follow the suggestions below to solve the problem.

  • Page 9: Maintenance

    MAINTENANCE Cleaning the front panel Wipe the surface with a soft, dry cloth. Cleaning the connector The connector needs to be cleaned occasionally. Wipe the surface of the connector with a cotton swab slightly moistened with alcohol. Back of the front panel SPECIFICATIONS RADIO SECTION (FM)
  • Page 10 Printed in Indonesia...

Table of Contents