Setting The Beep Tone; Setting The Clock - Aiwa CT-X419 Operating Instructions Manual

SETTING THE BEEP TONE
SETTING THE CLOCK
The unit is preset at the factory to beep each time
you press any button on the front panel except A,
A, + and -. You can stop beeping by
following the procedure below.
3
1
2,4
., . , ,.
With the unit off, press 1 and 4 at the
same time.
The "BEEP indication appears.
Each time you press them, this function turns
on or off.
The beep function is activated when the
"BEEP indication appears with the audio
control indicator lighting up and canceled
without the indicator.
Audio control indicator
1
2
3
4
Press PWR to turn the unit on.
Press and hold DISP for more than 2
seconds until the clock indication
flashes.
If you do not proceed with step 3 within 5
seconds, the clock indication disappears.
Press TUNE 7 to set the hour.
Press TUNE
A
to set the minute.
Press DISP to start working the clock
from O second.
Having the clock displayed while in Radio or
Tape Play mode
Press DISP. The clock display appears for 5
seconds, then the unit returns to its former display.
5
ENGLISH