Handle Up To 2002 - Stihl FC 75 Service Manual

8.6 Control Handle on Bike Handle up to 2002
8.6.1 Throttle Trigger/Interlock Lever
To avoid the risk of electrocution, do
not start the engine while the control
handle is exposed.
FS 75, 80, 85 only
: Take out the screw (arrow).
: Pull the handle off the handlebar.
: Take out the screws (arrows).
– Separate the handle moldings.
FC 75, FC 85, FH 75, FS 75, FS 80, FS 85, HL 75, KM 85, KW 85
1
2
: Lift the interlock lever (1) slightly
and turn it sideways until the
torsion spring (2) is relaxed.
: Pull the interlock lever off the
pivot.
: Remove the torsion spring
(arrow).
1
: Pull the throttle trigger (1) with
torsion spring (2) and attached
throttle cable (3) off the pivot.
: Disconnect throttle cable from
the throttle trigger.
Install in the reverse sequence.
: After attaching the throttle cable,
fit the torsion spring over the pivot
(arrow) and push its long leg into
the slot.
3
2
: The interlock lever must be
behind the throttle trigger.
– Tighten down the handle molding
mounting screws firmly, b 3.2
37