Rear Handle; Starting / Stopping The Engine - Stihl HS 82 Instruction Manual

English
With the filler cap in the filling neck,
N
twist it counterclockwise until it
drops into its seat.
Continue to twist the filler cap
N
counterclockwise (approx. 1/4 turn)
– this will twist the base of the cap
into the correct position.
While pushing down on the cap,
N
twist the filler cap clockwise and
close it – see section "Closing."
16

Rear Handle

2
1
The rear handle can be turned through
90° to the left or right for better control
and comfort in all cutting situations.
Let go of the throttle trigger. Do not
N
open the throttle.
Release the lock (1).
N
Turn the handle (2) to the required
N
position and re-engage the lock (1).
The throttle trigger may be used again
when the handle is locked in position.
Do not operate the throttle while the
handle lock is released. Never release
the lock while you are operating the
throttle.
Starting / Stopping the
Engine
Observe safety precautions – see
N
chapter on "Safety Precautions and
Working Techniques".
1
2
4
3
The stop switch (1) is in the normal run
position I.
Depress the trigger lockout (2) and
N
pull the throttle trigger (3) – hold
them in that position.
Press in the starting throttle lock (4).
N
Let go of the lockout lever, throttle
N
trigger and starting throttle lock.
This is the starting throttle position.
5
Set the choke lever (5) to
N
g if the engine is cold
e for warm start – also use this posi-
tion if the engine has been running
but is still cold.
HS 82 R, HS 82 T