Operating Instructions - Garrison 043-5494-2 Instruction Manual

Error codes:
E1- Room temperature sensor error -
Unplug the unit and plug it back in.
If error repeats, call for service.
E2- Evaporator temperature sensor error -
Unplug the unit and plug it back in.
If error repeats, call for service.
E4- Remove italics error -
and plug it back in. If error repeats,
call for service.
Protection codes:
P1- Bottom tray is full - Connect the
drain hose and drain the collected
water away. If error repeats, call
for service.
NOTE: When more than one code occur,
the priority of the code display order is:
E4--E2--E1--P1.

Operating Instructions

COOL operation
- Press the "MODE" button until the "COOL"
indicator light comes on.
- Press the ADJUST buttons " " or "
select your desired room temperature. The
temperature can be set within a range of
O O O
17 C-30 C/62 F-88 F.
- Press the "FAN" button to choose the fan speed.
DRY operation
- Press the "MODE" button until the
"DRY" indicator light comes on.
- Under this mode, you cannot select a
fan speed or adjust the temperature.
- Keep windows and doors closed for
the best dehumidifying effect.
- Do not install the duct in the window.
AUTO operation
- When you set the air conditioner in
AUTO mode, it will automatically select
cooling, heating (except in cooling-only models
7
OPERATING INSTRUCTIONS
Unplug the unit
▲
" to
O
), or fan only operation depen-
ding on what temperature you have
selected and the room temperature.
- The air conditioner will control the room
temperature automatically around the
temperature point set by you.
- Under AUTO mode, you can not
select the fan speed.
FAN operation
- Press the "MODE" button until the
"FAN" indicator light comes on.
- Press the "FAN" button to choose the
fan speed. The temperature cannot be
adjusted.
- Do nto install the duct in the window.
TIMER operation
- When the unit is on, first press the
TIMER button, The TIMER OFF
indicator light illuminates. It indi-
cates the Auto Stop program is
initiated.Press the Timer button
again, the TIMER ON
illuminates. It indicates the Auto
Start program has been initiated.
When the unit is off, first press the
TIMER button, The TIMER ON indic-
ator light illuminates. It indicates
the Auto Start program has been initiated.
When the unit.Press the Timer button
again, the TIMER OFF indicator light
illuminates. It indicates the Auto
Stop program is initiated.
- Press or hold the UP or DOWN
button to change the Auto time by
0.5 hour increments, up to 10 hours,
then at 1 hour increments up to 24
hours. The control will count down
the time remaining until start.
- The selected time will register in 5
seconds and the system will autom-
atically revert back to display the
previous temperature setting.
- Turning the unit ON or OFF at any
time or adjusting the timer setting
to 0.0 will cancel the Auto Start/
Stop timed program.
- When the malfunction (E1 or E2)
occurs, the Auto Start/Stop timed
program will also be cancelled.
indicator light