Garrison 043-5494-2 Instruction Manual page 13

Window
panel
Foam seal
Foam seal
11
INSTALLATION INSTRUCTIONS
Installation in a sliding sash window
Foam seal A 1. Cut the foam seal (adhesive type) to the proper length and
(adhesive type)
attach it to the window frame. See Fig. 12.
2. Attach the window slider kit to the window stool. Adjust the
length of the window slider kit according to the width of
Fig.12 window, shorten the adjustable window kit if the width of
window is less than 22.1 inches.
Open the window sash and place the window slider kit on
the window stool. See Fig. 13.
22.1 ~ 38.6
3. Cut the foam seal (adhesive type) to the proper length
and attach it on the left of the window. Shown as in Fig. 14.
4. Close the sliding sash securely against the window.
Fig.13
5. Cut the foam seal to an appropriate length and seal the
open gap between the right of the inner window sash and
outer window sash. Shown as in Fig. 15.
Fig.14
Fig.15
.