Exhaust Hose Installation - Garrison 043-5494-2 Instruction Manual

INSTALLATION INSTRUCTIONS
Fig.16
Fig.17
Expansion plug
position
Adaptor A
Adaptor
cap
max 120CM
min 30CM
Fig. 18
Fig. 19

Exhaust hose installation:

The exhaust hose and adaptor must be installed or removed
in accordance with the usage mode.
COOL,HEAT (heat pump type) or
FAN, DRY or HEAT (electrical heat type) mode
1. Install the window exhaust adaptor B onto the exhaust
hose as shown in Fig. 16. Refer to the previous
pages for window kit installation.
2. Push the exhaust hose into the air outlet opening along the
arrow direction (see Fig. 17)
The exhaust hose can be installed into the wall
(Not applicable to the units without adaptor A, expansion
plugs and wooden screws of accessories ).
1. Prepare a hole in the wall. Install the wall exhaust adaptor A
onto the wall (outside) by using 4 expansion plugs and
wooden screws, and be sure to fix thoroughly. (See Fig. 18)
2. Attach the exhaust hose to wall exhaust adaptor A.
Note:
Cover the hole using the adaptor cap when not in use.
The duct can be compressed or extended moderately
according to the installation requirement, but it is
desirable to keep the duct length to a minimum.
IMPORTANT:
DO NOT OVER BEND THE DUCT (See Fig. 19)
CAUTION:
Make sure that there is no obstacle around the air outlet of
the exhaust hose (in the range of 500 mm) in order for the
exhaust system to work properly.
AUTO mode Install
Remove
12