ADTRAN 3.125 Job Aid

CLEI: VAUIMJP_ _
Product P/N: 1440882G1
DESCRIPTION
The Small Form-Factor Pluggable (SFP) 3.125 Gigabit
Ethernet is a single mode fiber SFP that plugs into a
module designed to accept SFPs. The SFP provides a
dual optical interface to the 3.125 Gigabit Ethernet
physical interface. Installed into an appropriate module,
the SFP provides 3.125 Gigabit Ethernet tributary
interface to the supporting system.
NOTE: This SFP should not be used in applications
requiring standard Gigabit (1000Base) Ethernet
services.
The following features are supported on the SFP:
♦ 3.125 Gigabit Ethernet data rate
♦ 1310nm Transmitter
♦
Wavelength: 1310nm
♦ Optical distance: 40 km maximum
CAUTION: Due to compliance certification requirements,
only SFPs supplied by ADTRAN should be used.
ADTRAN cannot certify system integrity with
other SFPs.
Operational Specifications
♦
Optical Specifications:
– Optical transmit level: –2 dBm to +3 dBm
– Optical receive level: –27 dBm to –9 dBm
– Optical budget: 14 dB
– Optical connectors: LC
– SFF 8472 Digital diagnostic compliant
– Compatible with SFP MSA
Small Form-Factor Pluggable
3.125 Gigabit Ethernet 40 km
♦
Extended Environmental Support:
– Operational temperature range: –40°C to +85°C
– Storage temperature range: –40°C to +85°C
– Relative humidity to 95%, noncondensing
INSTALLATION
To install the SFP into an appropriate module, complete
the following steps:
1. Inspect the SFP. If damaged, file a claim with the
carrier and then contact ADTRAN Customer Service.
2. Do not remove the protective end cap from the SFP
until the fiber optic cable is ready to be connected.
3. Insert the SFP into the SFP cage on the module.
Ensure the manufacturer's label on the SFP is facing
upward for correct installation.
4. Slide the SFP all the way into the receptacle until
there is an audible "click".
NOTE: The latch on the SFP is used to remove the SFP from
the cage on the circuit card
Issue Date: 0803
Document P/N: 61440882G1-22A