Table of Contents
Advertisement
HC05EVS Configuration and Operation
Introduction
32
The following paragraphs explain how to configure and use your
M68EM05P18 as part of an HC05EVS. For other parts of system
installation or configuration, see the HC05EVS Operations Manual
(HC05EVSOM/D). If you use your M68EM05P18 as part of an
MMEVS05 or MMDS05, refer to MMDS/MMEVS Configuration and
Operation on page 19 for corresponding information.
The topics covered in this chapter are:
•
Setting M68EM05P18 Jumper Headers and Switches on page
33 explains how to set the M68EM05P18 jumper headers.
•
Remaining System Installation on page 37 covers the final
steps to system installation.
•
MC68HC(8)05P18 Emulation on page 38 explains
considerations pertaining to the MCU you emulate.
•
HC05EVS Limitations on page 41 explains limitations on using
the M68EM05P18 in an HC05EVS.
NOTE:
Note that you can configure an M68EM05P18 already
installed in the HC05EVS platform board. To do so,
disconnect platform board power, then follow the guidance of
this chapter.
CAUTION:
Be sure to switch off power before you reconfigure an
installed EM. Reconfiguring EM jumper headers with
power left on can damage HC05EVS circuits.
HC05EVS Configuration and Operation
Introduction
M68EM05P18UM/D
MOTOROLA
Advertisement
Table of Contents
