Table of Contents
Advertisement
MMDS/MMEVS Configuration and Operation
Introduction
20
The following paragraphs explain how to configure and use your
M68EM05P18 as part of an MMDS or MMEVS system. For other parts
of system installation and configuration, see either the MMDS05
Operations Manual (MMDS05OM/D) or MMEVS05/MMEVS08
Operations Manual (MMEVS0508OM/D). If you use your M68EM05P18
as part of an HC05EVS, refer to HC05EVS Configuration and
Operation on page 31 for corresponding information.
The topics covered in this chapter are:
•
Setting M68EM05P18 Jumper Headers and Switches on page
21 explains how to set the M68EM05P18 jumper headers.
•
Remaining System Installation on page 25 covers the final
steps to system installation.
•
Personality File Usage on page 26 discusses how the
personality file is used on the M68EM05P18 board.
•
MC68HC(8)05P18 Emulation on page 26 explains
considerations pertaining to the MCU you emulate.
NOTE:
You can configure an M68EM05P18 already installed in the
system platform board. To do so, remove system power and
then follow the guidance of this chapter.
CAUTION:
Be sure to switch off power before you reconfigure an
installed EM. Reconfiguring EM jumper headers with the
power on can damage emulation circuits.
MMDS/MMEVS Configuration and Operation
Introduction
M68EM05P18UM/D
MOTOROLA
Advertisement
Table of Contents
