•
Figure 77: Sales order
•
Figure 79: History
•
Figure 81: Security log
•
Figure 82: Trend
•
Figure 83: Custom screen
•
Figure 84: ACC New map points report
•
Figure 85: ACC Existing map points report
Acceptable printers
The following printers can be used. Printers must be equipped with an RS- 232 Serial interface.
Okidata
Models: OKIPOS 441
•
Dimensions: 6.9 in. wide x 9.64 in. deep x 5.98 in. high
•
Paper: 3.0 in. wide
•
Type: Dot Matrix Impact
•
Purchase: 800-OKIDATA Spare printer Ribbon Okidata 52119001 Black
The Control Center provides the required formatting control codes for the printers above when the
printer is selected on the PRINTER Screen in the instructions below. These codes are transmitted
through the serial interface to the printer to provide a proper print format.
Different printers require different formatting control codes. Other printers might provide proper
operation when connected to the Control Center. However, the print format may not be correct or
as desired.
Proceed with caution and use the following guidelines if an unlisted printer is selected:
1.
All must be capable of RS-232 serial communications.
2.
Primary differences between printers involve the formatting control codes required by
the printer. These codes are sent from the Control Center to the printer. For example,
Weigh-Tronix printers require a control code to select 40 column width. This same code
is interpreted by the Okidata printer as an instruction to print wide characters. In some
instances, a printer will ignore a code it cannot interpret.
3.
The Control Center requires a busy signal from the printer when the printer receive buffer
is full. This causes the Control Center to momentarily terminate data transmission until the
printer can accept more data. The busy signal polarity must be asserted low when busy.
YK-EP Style B Centrifugal Chiller
221