Table of Contents
Advertisement
Connecting Welding Power Cables to Contact
Nozzle Assembly - All Configurations
1. Rotate the brass bar on the nozzle towards the base of the
Cruiser™ tractor. To rotate, loosen the two screws holding the
nozzle clamps.
Rotate the nozzle assembly and retighten the two screws.
2. Attach the electrode cable to the nozzle tang using the 1/2-inch
bolt supplied:
a. Attach flat side against tang.
b. Place connection lug of sense lead
on top of the cable lug and below the
bolt head.
c. If a second cable is used, attach it to
the underside of the tang.
3. Place the cable (or cables) underneath
the strain-relief bracket mounted to the
Cruiser™ tractor. Enough cable length
must be left toward the front of the
Cruiser™ tractor to permit attaching to
the K-231 contact nozzle assembly.
Note: Enough slack must also be
provided, so adjusting the
welding torch to the desired
position is not interfered.
9-6
CABLES AND CONNECTIONS
Cruiser™ Tractor
9-6
Advertisement
Table of Contents
