Care And Safety - Minelab GPX 6000 User Manual

Care and Safety

Operate and maintain your detector following the below recommendations to ensure
its safe use and long life�
Do not submerge the detector body in water — it is rain‑proof only�
`
` All GPX 6000™ coils are waterproof to 1 metre (3�3 feet), however care must be taken to ensure the coil connector
is not submerged�
` The battery pack is not waterproof — Do not immerse the battery pack in any liquid or allow water ingress�
` Wash your hands before handling the detector after applying sunscreen or insect repellents�
Do not use solvents to clean� Use a damp cloth with a mild soap detergent�
`
` Never allow the detector to come into contact with gasoline/petrol or other petroleum‑based liquids�
` Avoid getting sand and grit in the shafts and fastenings (e�g� coil yoke assembly and twist locks)� If sand and grit
accumulates in these parts they should be thoroughly rinsed and dried�
` Do not bring the detector or accessories into contact with sharp objects as this may cause scratches and damage�
` Do not leave the detector in excessive cold or heat longer than necessary� Covering it when not in use will help protect it�
Avoid leaving it in a hot vehicle�
` Ensure the coil cable is in good condition and not subject to undue stress�
Take precautions when transporting or storing the detector� Although the detector is constructed from the highest
`
quality materials and has undergone rigorous durability tests, the detector parts and display screen could become
scratched or seriously damaged if not treated with due care�
` Do not expose the ML 100 headphones or charging accessories to liquid/moisture or excessive humidity�
` Do not allow children to play with the detector or included accessories — small parts can be a choking hazard�
Only charge rechargeable batteries and accessories according to the instructions provided�
`
` Avoid charging rechargeable batteries and accessories in extreme temperature conditions�
` Remove battery prior to air transportation�
DISCLAIMER
The Minelab metal detector described in this instruction manual has
been expressly designed and manufactured as a quality metal detector
and is recommended for treasure and gold detecting in non‑hazardous
environments� This metal detector has not been designed for use as a
landmine detector or as a live munitions detection tool�
The Bluetooth® word mark and logos are registered trademarks owned by the
Bluetooth SIG, Inc� and any use of such marks by Minelab is under license�
This work is licensed under the Creative Commons Attribution‑
NonCommercial‑NoDerivatives 4�0 International (CC BY‑NC‑ND 4�0)
International License� To view a copy of this license, visit:
http://creativecommons�org/licenses/by‑nc‑nd/4�0/
CONTENTS
Qualcomm aptX is a product of Qualcomm Technologies, Inc� and/or its
subsidiaries� Qualcomm is a trademark of Qualcomm Incorporated,
registered in the United States and other countries� aptX is a trademark of
Qualcomm Technologies International, Ltd�, registered in the United States
and other countries�
MINELAB®, GPX 6000™, GeoSense‑PI™, GPX 11™, GPX 14™, and GPX 17™ are
trademarks of Minelab Electronics Pty� Ltd�
25