Care And Troubleshooting; Routine Care - Minelab F3 Compact Operation Manual

Care and Troubleshooting

Routine Care

The F3 Compact is designed for lasting use in harsh operating environments,
however, proper care and maintenance will ensure long-term reliability. Key to
ensuring the durability of the F3 Compact is the correct stowage of the detector
when it is not in use.
Additionally, operators of F3 Compact detectors should be aware of the following:
a. During rest periods, wherever possible, the detector should be sheltered from
direct sun, rain, snow etc.
b. On completion of operations, with the F3 Compact fully extended, all shafts
should be wiped with a damp cloth to remove any dirt or dust before collapsing
the shafts.
c. Do not use solvents or chemicals to clean the F3 Compact. If any part of the
detector comes into contact with corrosive substances (including salt water),
wash the detector with clean fresh water and dry with a clean cloth.
d. Ensure the F3 Compact is dry before stowing in the Soft Carry Bag.
e. Ensure the batteries are removed from the Battery Compartment before
stowing the detector.
f. The Skid Plate is designed to protect the coil and may require replacement
after long periods of use. There is no requirement to remove the Skid Plate to
clean the inside during routine maintenance.
g. To replace the Skid Plate, remove the original using fingers to lever it from the
coil, then push the replacement Skid Plate onto the coil (see Figure 28).
F3 Compact Operations Manual
Figure 28: Replacing the Skid Plate
Care and Troubleshooting | 37