Connection; Cordless 1-Line - Ctm-A2415 - VTech Analog Contemporary Series Master User Manual

4. To replace the handset cover, align all
the tabs on the handset cover against the
corresponding grooves on the handset,
then firmly push downward until all the tabs
lock in the grooves. Then install the screw.

Connection

Cordless 1-line - CTM-A2415

Telephone base installation
The telephone comes ready for desktop use.
1. Install the telephone base as shown below.
Telephone
wall jack
Telephone
line cord
If you have High
Speed Internet Access
service, a DSL filter (not
included) is required.
2. When the telephone base has been initially
installed, make sure the power adapter is
securely plugged into an outlet not controlled
by a wall switch, and the telephone line cord is
plugged firmly into the power adapter and the
telephone wall jack.
3. Bend a small paperclip and gently insert it
to the Base battery ON pinhole and Handset
battery ON pinhole to turn on the base and the
handset.
• Without turning on the battery, the base and
the handset cannot be charged.
• Charge the base to enable battery backup
feature.
• The battery is fully charged after 12 hours of
continuous charging. For best performance,
keep the cordless handset in the telephone
4. Press SPEAKER on the telephone base.
Listen for a dial tone, and then press SPEAKER
again to hang up.
Use only the supplied cable and power
adapter. The supplied cable is not designed for
use in any other IT devices. Misuse it on your
other IT devices shall be prohibited. To order a
replacement, call 1-888-907-2007.
Power
cord
connector
EN - 12
base when not in use.
CAUTION