Fiat BRAVO Owner's Handbook Manual page 82

CRUISE CONTROL
GETTING TO
(constant speed regulator)
KNOW YOUR CAR
(for versions/markets, where provided)
This is an electronically controlled driving assistance
device which allows the car to be driven at a
SAFETY chosen speed above 30 km/h on long stretches of
dry, straight roads with few variations (e.g.
motorways), without having to depress the
accelerator pedal.
STARTING AND
The use of this device on extra-urban roads with
DRIVING
traffic is not therefore recommended. Do not
use the device in town.
WARNING LIGHTS
TURNING THE DEVICE ON
AND MESSAGES
Turn the ring nut A fig. 56 to the ON position.
IN AN EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
fig. 56
78
The device must only be switched on in 4th gear or
higher. When travelling downhill with the device
engaged, the vehicle speed may slightly exceed the
preset one.
The activation is indicated by the turning on of
warning light
with the dedicated message on the display) (see
"Warning lights and messages" chapter).
STORING THE VEHICLE SPEED
Proceed as follows:
❒ turn ring nut A fig. 56 to ON and press the
accelerator pedal so that the car reaches the
desired speed;
❒ turn the ring nut B to (+) for at least three
seconds, then release it. The vehicle speed is now
memorised and you can therefore release the
accelerator pedal.
If needed (when overtaking for instance), you can
accelerate simply by depressing the accelerator
pedal; when you release the pedal, the vehicle goes
back to the speed set previously.
RESTORING STORED SPEED
If the device has been switched off, for example by
depressing the brake or clutch pedal, the
memorised speed can be restored as follows:
❒ accelerate progressively until a speed close to
that stored is reached;
F0Q0648
on the instrument panel (together