Fiat BRAVO Owner's Handbook Manual page 197

CYLINDER REPLACEMENT PROCEDURE
To replace the cylinder, proceed as follows:
❒ disconnect coupling B fig. 156;
❒ turn the cylinder to be replaced anticlockwise
and raise it;
❒ fit the new cylinder and turn it clockwise;
❒ connect coupling B to the cylinder and fit
transparent pipe A in the specific compartment.
fig. 156
CHANGING A BULB
GENERAL INSTRUCTIONS
❒ Before changing a bulb check the contacts for
oxidation;
❒ Burnt bulbs must be replaced by others of the
same type and power;
❒ after replacing a headlight bulb, always check its
alignment;
❒ when a light is not working, check that the
corresponding fuse is intact before changing
a bulb. For the location of fuses, refer to the
paragraph "If a fuse blows" in this section;
Modifications or repairs to the electric
system that are not carried out
properly or do not take the system technical
specifications into account can cause
malfunctions leading to the risk of fire.
Halogen bulbs contain pressurised gas,
in the case of breakage they may burst.
F0Q0512
WARNING
WARNING
GETTING TO KNOW
YOUR CAR
SAFETY
STARTING AND
DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
193