Fiat BRAVO Owner's Handbook Manual page 80

Activation
GETTING TO
Move the right stalk down by one click.
KNOW YOUR CAR
The activation of the sensor is signalled by a
"stroke" to show that the command has been
acquired.
SAFETY
IMPORTANT Keep the glass in the sensor area
clean.
By turning ring nut F fig. 51 is it possible to increase
STARTING AND
the sensitivity of the rain sensor to obtain a more
DRIVING
rapid variation between wiper still (no stroke)
when the windscreen is dry, to wiper at first
continuous speed (slow continuous operation).
WARNING LIGHTS
The increasing of the rain sensor sensitivity is also
AND MESSAGES
signalled by a stroke of the wipers.
If the windscreen washer is used with the rain
sensor activated, the normal washing cycle is
IN AN EMERGENCY
performed, after which the rain sensor resumes its
normal automatic operation.
SERVICING AND
Deactivation
MAINTENANCE
Turn the ignition key to STOP.
At the next start-up (key at MAR-ON), the sensor
will not be reactivated even if the stalk is at B
TECHNICAL
fig. 51. To activate the sensor, move the stalk to
SPECIFICATIONS
position A or C and then back to position B.
Rain sensor activation will be indicated by at least
one wiper "stroke" even if the windscreen is dry.
INDEX
76
Do not activate the rain sensor when
washing the car in an automatic car
wash.
Make sure the device is switched off if
there is ice on the windscreen.
WARNING
Make sure the device is switched off
whenever the windscreen is being
cleaned.
REAR WINDOW WASHER/WIPER
It can be operated only with the ignition key turned
to MAR-ON. The function stops when the stalk is
released.
Turning the stalk ring nut A fig. 54 from position
to position will operate the rear window
wiper as follows:
❒ in intermittent mode when the rear window
wiper is not operating;
❒ in synchronous mode (at half the speed of the
windscreen wiper) when the windscreen wiper
is operating;
❒ in continuous mode with reverse gear engaged
and the control active.