Lexus Lx470 Owner's Manual page 257

■ Programming a Rolling Code system (for U.S.A. owners)
If your device is Rolling Code equipped, follow the steps under the
heading "Programming the HomeLink
steps listed below.
Locate the training button on the ceiling mounted garage door
STEP 1
opener motor. The exact location and color of the button may
vary by brand of garage door opener.
Refer to the operation manual supplied with the garage door opener
for the location of the training button.
Press the training button.
STEP 2
Press and release the vehicle' s programmed HomeLink
STEP 3
twice. The garage door may open.
If the garage door opens, the programming process is complete. If the
door does not open, press and release the button a third time. This third
press and release will complete the programming process by opening
the garage door.
The ceiling mounted garage door opener motor should now recognize

the HomeLink
Repeat the steps above to program another rolling code system
STEP 4
for any of the remaining HomeLink
■
Programming an entry gate (for U.S.A. owners)/Programming all
devices in the Canadian market
Place your transmitter 1 to 3 in. (25 to 75 mm) away from the sur-
STEP 1
face of the HomeLink
Keep the indicator light on the HomeLink
Press and hold the selected HomeLink
STEP 2
Repeatedly press and release (cycle) the device' s remote control
STEP 3
button for two seconds each until step 4 is complete.
When the indicator light on the HomeLink
STEP 4
ceiver start to flashing rapidly, release the buttons.

" before proceeding with the
transceiver and operate the garage door.


.
3-5. Other interior features

button
buttons.

in view while programming.

button.

compatible trans-
3
239