Lexus Lx470 Owner's Manual page 181

Connecting trailer lights
Use the wire harness stored in the rear end under body.
When connecting and disconnecting a trailer
■
Connecting
Set the active height control suspension to "LO" mode.
STEP STEP 1 1
Turn off the ignition switch or the active height control suspension.
STEP 2
STEP 2
Connect the trailer.
STEP STEP STEP 3 3 1
Turn on the switch that was turned off on step 2.
STEP STEP STEP 4 4 1
Set the active height control suspension to "N" mode.
STEP STEP STEP 5 5 1
Disconnecting
Set the active height control suspension to "LO" mode.
STEP 1
STEP 1
Turn off the ignition switch or the active height control suspension.
STEP STEP 2 2
Set the supporting leg of the trailer on the ground and raise the hitch by 4
STEP 1
STEP STEP 3 3
in. (100 mm).
Turn on the switch that was turned off on step 2.
STEP 1
STEP STEP 4 4
Wait until vehicle height is stabilized.
STEP STEP STEP 5 5 1
Make sure the hitch is disconnected. If the hitch does not disconnect, raise
STEP 1
STEP STEP STEP 5 6 6
the hitch higher and repeat steps 2 through 5.
Move the vehicle forward in the "LO" mode to a point where the hitch
STEP 1
STEP STEP STEP STEP 6 7 7 5
does not touch anything in the "N" mode.
Set the active height control suspension in the "N" mode.
STEP STEP STEP STEP STEP 8 6 5 8 1
2-5. Driving information
163
2