Usage Notice; Safety Instructions - LG BS275 Manual

Usage Notice

Safety Instructions

Please take note of the safety instructions to prevent any poten-
tial accident or misuse of the projector.
Safety Instructions are given in two forms as detailed below.
WARNING : The violation of this instruction may cause serious injuries and even death.
NOTES : The violation of this instruction may cause injuries or damage to the projector.
After reading this manual, keep it in the place that you can access easily.
Indoor Installation
Do not place the Projector in direct
sunlight or near heat sources such
as radiators, fires, stove etc.
This may cause a fire hazard !
Do not block the vents of the pro-
jector or restrict air-flow in any way.
This would cause the internal tem-
perature to increase and could cause
a fire hazard or damage to the unit!
Do not use the projector in a damp
place such as a bathroom where it
is likely to get wet.
This may cause a fire or an electric
shock hazard!
Indoor Installation
When installing the projector on a
table, be careful not to place it near
the edge.
The projector could fall causing injury
and damage to the projector.
Only use a suitable stand.
Power
Earth wire should be connected.
Ensure that you connect the earth ground wire
to prevent possible electric shock (i.e.a Projector
with a three-prong grounded AC plug must be
connected to a three-prong gronded AC outlet.
If grounding methods are not possible, have
a qualified electrician install a separate circuit
breaker.
Do not try to ground the unit by connecting it to
telephone wires, lightening rods, or gas pipes.
2
English
All manuals and user guides at all-guides.com
WARNING
Do not place flammable materials Do not hang on the installed
in, on or near the projector projector.
This may cause a fire hazard!
It may cause the projector to fall,
causing injury or death.
Do not place the projector close to Do not place the projector where it
sources of steam or oil such as a might be exposed to dust.
humidifier.
This may cause a fire hazard or dam-
age to the unit!
This may create a fire hazard or an
electric shock hazard !
Do not place the projector directly
Ensure good ventilation around the
on a carpet, rug or place where
projector. The distance between
ventilation is restricted.
the projector and the wall should be
more than 30cm/12 inches.
This would cause its internal tempera-
ture to increase and might create a fire
An excessive increase in its internal
hazard or damage the unit.
temperature may cause a fire hazard
or damage to the unit!
NOTES
Disconnect from the power supply Only use the projector on a level
and remove all connections before and stable surface.
moving, or cleaning.
It may fall and cause injury and/or
damage to the unit.
WARNING
The power cord should be inserted
Do not place heavy objects on the
fully into the power outlet to avoid
power cord.
a fire hazard!
This may cause a fire or an electric
This may cause a fire hazard or dam- shock hazard !
age the unit.