Table of Contents
Advertisement
Available languages
Available languages
10.0 finishing
finishing
EN
WARNING
!
•
Risk of fire!
•
Never obstruct the front opening of the appliance.
•
The front of the appliance must be finished with any non-combustible materials such as brick, marble, granite,
etc., provided that these materials do not go below the specified dimension, as illustrated.
•
Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, or scratched.
•
Facing and/or finishing material must never overhang into the appliance opening.
•
The glass door assembly is designed to pivot forward when relieving excess pressure that might occur. Finishing
or other materials must not be located in the opening surrounding the door as this will interfere with the doors
ability to relieve pressure.
10.1 log shipping bracket
Before installing the logs, you must first remove the log shipping
bracket. Remove the indicated securing screws. Lift up to remove.
10.2 decorative panels
This appliance does not include decorative brick panels, however, panels are required. Panel kits are sold sepa-
rately. Consult your local authorized dealer / distributor. Refer to the 'replacements' section.
10.3 safety barrier & glass door installation / removal
WARNING
!
•
Glass may be hot. Do not touch glass until cooled.
•
If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
•
Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
•
Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
A barrier designed to reduce the risk of burns from the hot viewing glass is provided with the
appliance and must be installed.
Before the glass door can be removed, the safety screen must be removed. Lift the safety screen off the 4 pins,
tilt the top forward and remove from the appliance.
Leave a hand on the glass door during entire door removal. The glass door is secured
to the firebox with 2 spring latches along the top and 2 along the bottom. Pull the
handles of the latches forward, then lift the latches out from the door frame to release
the top of the door. Repeat the same step for the 2 bottom latches. Next, pivot the
door forward until the top edge clears the front of the appliance. Carefully grip the
sides of the door lifting it off the appliance.
note:
These spring latches make up the spring relief system for the appliance. Ensure
they open freely and close sealed.
Reverse these steps to re-install the safety screen and door. Ensure safety screen is installed correctly.
32
W415-2371 / D / 01.05.21
Screws
Log Shipping
Bracket
47.1
Advertisement
Chapters
Table of Contents
