Power Cord (Ac1) - Sony HCD-SX7 Service Manual

HCD-SX7/SX7B

2-22. POWER CORD (AC1)

Note 1: During reassembly, use new binding band
(taiton) to fasten the wires back in place as
they were before disassembly.
5 clamp filter (ferrite core) (FC6)
4 Cut the binding band (taiton).
6 power cord (AC1)
2 cord bush (2104)
1 Remove the cord bush (2104)
in the direction of the arrow.
Note 2: Coil the power cord (AC1) twice
Note 3: Coil the power cord (AC1) three times
clamp filter
(ferrite core)
cord bush (2104)
(FC6)
180 ± 5 mm
28
3 power cord connector
(CN101)
–
to the clamp filter (ferrite core) (FC6).
to the clamp filter (ferrite core) (FC6).
binding band (taiton)
power cord (AC1)
power unit
75 to 80 mm
(CN101)
–
Insert the connector straight into the interior.
There is a possibility that using this unit without
the connector correctly installed will damage it.
OK
Insert straight into
the interior.
connector
to
connector
clamp filter
power cord
(ferrite core) (FC6)
(AC1)
cord bush (2104)
NG
Insert only part way. Insert at a slant.
connector
connector
connector connector
NG
SYS SET