Panel (Front) Block-1 - Sony HCD-SX7 Service Manual

2-7.

PANEL (FRONT) BLOCK-1

• Continued on 2-8 (page 18).
6 filament tape
(sub material)
4 USB-HP board CN1501
cable connector
(CN605)
5 USB-HP board CN1501
cable connector
(CN1101)
How to install the connector
Insert the connector straight into the interior.
There is a possibility that using this unit without
the connector correctly installed will damage it.
OK
Insert straight into Insert only part way.
the interior.
connector
connector
connector
How to install the flexible flat cable
When installing the flexible flat cable, ensure that
the colored line is parallel to the connector after insertion.
OK
Insert straight into the interior.
flexible flat
cable
colored line
connector
7 sleeve ferrite clamp
(FC1)
terminal side
NG NG
Insert at a slant.
connector
connector connector
NG
Insert at a slant.
flexible flat
cable
colored line
connector
1 two filament tapes
(sub material)
3 flexible flat cable (11 pin)
2 USB-HP board CN1501
– Rear view –
cable connector
(CN601)
filament tape
(sub material)
Front
side
MAIN board
HCD-SX7/SX7B
(CN011)
filament tape
(sub material)
sleeve ferrite clamp filament tape
(FC1) (sub material)
17
SYS SET