2-25. LOUDSPEAKER (65 mm) BLOCK-1 (SP1, SP2)
• Continued on 2-26 (page 36).
Note 2: When you install the connector, please install them correctly.
There is a possibility that this machine damages when not
correctly installing it.
OK
Insert is straight
Insert is shallow
to the interior.
connector
connector
connector
FFC cushion (USB)
2 Remove the speaker wire
from groove of rear panel block.
OK
The edge of the cushion
is aligned.
2 to 3 mm
NG
NG
Insert is incline
connector
connector
connector
1 FFC cushion (USB)
4 connector
(CN103)
3 connector
(CN102)
NG
The edge of the cushion
is inside.
CMT-X5CD/X5CDB/X7CD/X7CDB
CN102
Note 1: Connect the wire so that it does not
cover the remote commander receiver.
1 FFC cushion (USB)
2 Remove the speaker wire
–
OK
NG
The edge of the cushion
The edge of the cushion
is aligned.
is inside.
2 to 3 mm
RC board
FFC cushion (USB)
from groove of rear panel block.
–
Ver. 1.1
35