Bluetooth Module Block, Main Chassis Block-2 - Sony CMT-X5CD Service Manual

2-5.

BLUETOOTH MODULE BLOCK, MAIN CHASSIS BLOCK-2

• Continued on 2-6 (page 18).
2 three screws
(BTTP M2.6)
4 BCO cushion
boss
Wire setting
MAIN board
flexible flat cable (7P)
(FFC3)
1 four screws
(BVTP2.6)
– Front bottom view –
3 Remove the main chassis block
in the direction of the arrow.
6 Peel off the
adhesive sheet.
5 cushion
(touch)
cushion (touch) BCO cushion
CMT-X5CD/X5CDB/X7CD/X7CDB
Note 1: When installing the flexible flat cable,
hole
hole
How to install the main chassis block
Note 2: When installing the main chassis block,
align two bosses and two holes.
Note 3: When installing or removing the main chassis block,
be sure to use both hands. Do not perform either
procedure using only one hand.
both hands
ensure that the colored line is not
slanted after insertion.
OK
Insert is straight to the interior.
flexible flat
cable
colored line
connector
NG
Insert is incline
flexible flat
cable
colored line
connector
main chassis block
Wire setting
Note 4: When installing the main
chassis block, be careful
not to pinch the flexible
flat cable between the
main chassis block and
the rear panel block.
boss
7 flexible flat cable (7P)
(CN004)
OK NG
one hand
17