Installation - Sony DSC-WX1 Service Manual

2-4. ZOOM GEAR BLOCK REPLACING METHOD
Removal
1 Remove one screw.
2 Remove the Zoom Gear Block upward.
3 Remove the Naruto Gear.
4 Remove the Z Tape.
Note: The Z Tape is not supplied. Please reuse.
5 Disengage two claws A and B in this order to remove the FG Plate Spring.
Note: The FG Plate Spring cannot be reused.
6 Remove two sensors on the lens flexible board.
7 Break two solders, and remove the lens flexible board.

Installation

1 Confirm the direction of Zoom Gear Block, and install the lens flexible board with two solders.
2 Install two sensors of Zoom Gear Block.
3 Engage two claws A and B in this order to install FG Plate Spring.
4 Stick the Z Tape.
5 Install Naruto Gear (S).
6 With four bosses fitted in position, install Zoom Gear Block.
7 Tighten one screw.
* Tightening torque = 0.068 ± 0.01N • m (0.7 ± 0.1kgf • cm)
Z Tape
Claw A
Solders
DSC-WX1_L2
Screw
Zoom Gear Block
Naruto Gear
FG Plate Spring
Claw B
Zoom Gear Block
Sensors
Z Tape
Claw B
Solders
Screw
Front Side Rear Side
Bosses
2-7
FG Plate Spring
Claw A
Zoom Gear Block
Sensors
Zoom Gear Block
Naruto Gear
Bosses