Installation - Sony Cyber-shot DSC-RX100M3 Service Manual

1-9. ORNAMENTAL RING (A) OR BARRIER BLOCK ASSY REPLACING METHOD
Removal
1. Turn on the power switch and extend the lens (WIDE end).
2. Detach the battery.
3. Apply alcohol to the gap of the Ornamental Plate using tweezers or fine-tipped stick as shown below.
4. Detach the Ornamental Ring (A).
Note: Do not turn the Ornamental Ring (A) because there is a
Positioning Boss. Detach the Ornamental Ring A in the
arrow direction.
Tweezers
Solvent
Boss
5. Disengage the four claws and remove the Barrier Block Assy.
Claws
Barrier Assy
Claws

Installation

1. Fit the four claws while inserting the barrier lever into the hole and attach the Barrier Block Assy.
Barrier Block Assy
Claws Barrier
Lever
Claws
Hole
2. Peel off the release paper of the Barrier Tape.
3. Install the Ornamental Ring (A) and press it lightly.
Barrier Tapes
Barrier Tapes Barrier Block Assy
DSC-RX100M3/RX100M3G_L2
Note:
Ornamental Ring (A)は，位置決めのボスがあるため，
左右にひねらず矢印方向に取り外してください。
Ornamental Ring (A)
Ornamental Ring (A)
1-10. 1 GROUP FRAME BLOCK ASSY REPLACING METHOD
Removal
1. Peel off the Insulating Sheet (ST3).
Insulating Sheet (ST3)
2. Remove the three screws to detach the Spacer Plates and the CD-847 Flexible Board.
Seal Rubber
Spacer Plate
CD-847 Flexible Board
Spacer Plates
3. Remove the FG Retainer.
FG Retainer
Claws
4. Pull out the FG-PI of front side, and then pull out the FG-PI of rear side.
2 FG-PI (rear side)
Hook
1 FG-PI (front side)
1-9
SYS SET