Sony STR-DN1080 Service Manual page 98

STR-DN1080/ZA810ES
REVISION HISTORY
Ver. Date
1.0 2017.03 New
1.1 2017.05 Addition of Taiwan model (STR-DN1080)
Addition of Part for RIVET (Ref. No. 53) and SHIELD PLATE (Not supplied)
Change of Part for SCREW (Ref. No. #11) (STR-DN1080: AEP, UK, AUS)
Change of Part No. for FRONT PANEL ASSY (Ref. No. 252)
1.2 2019.04 Addition of Description for Protector type in HISTORY MODE of TEST MODE
1.3 2020.11 Addition of "NOTE OF REPLACING THE FUSE" on SERVICING NOTES
Change of MB-1613 board (Suffi x-21)
Change of Part for Ref. No. D1356 and IC1231 on the MAIN board
Change of Part No. for Ref. No. RY1301, RY1302, RY1350, RY1355, RY1360, RY1365, RY1390 and
RY1391 on the MAIN board (RY1391 is STR-DN1080: US, CND/ZA810ES only)
Deletion of Part for Ref. No. C1071 on the DCDC board
Change of Part from CLAMP (L35) (Ref. No. 4) to CLAMP (N) (not supplied)
Change of Part No. for POWER-SUPPLY CORD (Ref. No. AC1) (STR-DN1080: AEP, UK)
Change of Part No. for POWER TRANSFORMER (Ref. No. T901)
Change of Part No. for OPERATING INSTRUCTION
How to search for a contact point of signal lines or the like in DIAGRAMS SECTION
If a contact point of a BLOCK DIAGRAM, PRINTED WIRING BOARD or SCHEMATIC DIAGRAM is shown in a diff erent page, use
the PDF fi le search function to fi nd one.
e.g.) If a contact point is shown as
Procedure:
1. Press the [F] key while pressing the [Ctrl] key.
2. Input ">001Z" in the search box and press the [Enter] key.
3. The relevant part (page), where the contact point is shown, appears.
Note: If you still see the original page, press the [Enter] key again.
Description of Revision
, follow the procedure below.
(STR-DN1080: AEP, UK, AUS)
(SMR-17005)
(SMR-19002)
(SMR-20025)
SYS SET