Sony STR-DN1080 Service Manual page 36

STR-DN1080/ZA810ES
Ver. 1.1
SOFTWARE VERSION DISPLAY MODE
The model, destination and software version are displayed
Procedure:
1. While pressing the [2CH/MULTI] and [PURE DIRECT] but-
tons, press the [ ] button to turn the power.
1
2. The model and destination is displayed.
Destina-
Model
tion
US, CND
(UC2)
AEP (CEL),
STR-
UK (CEK)
DN1080
AUS (AU1)
TW (TW2)
STR- US, CND
ZA810ES (UC2)
3. Each time the [DISPLAY MODE] button is pressed, the dis-
play is changed in order as follows.
Model and Destination
System software version
Main system controller (IFcon) software version
OSD software version
DSP1 serial flash software version
DSP2 serial flash software version
DSP3 serial flash software version
(Displayed characters/values in the above fi gure are example)
Releasing method:
Press a button more than the [DISPLAY MODE] button.
36
Display
N 1 0 8 U C A
N 1 0 8 C E L
N 1 0 8 A U
N 1 0 8 T W
Z 9 U C A
KEY CHECK MODE
Each button can be checked.
Procedure:
1. While pressing the [SPEAKERS] and the [PURE DIRECT]
buttons, press the [ ] button to turn the power on.
1
2. The message "REST 12" appears.
3. Every pressing of any button other than the [
the buttons.
(The buttons which are already counted once are not counted
again)
4. When all buttons are pressed "REST 00" appears.
Releasing method:
Press the [ ] button on the remote commander to turn the power
1
off .
PROTECTOR AUTO OFF
The auto off function after protection generating can be disabled.
Procedure:
1. While pressing the [MOVIE] and [DISPLAY MODE] buttons,
press the [ ] button to turn the power on.
1
2. The message "PROTEVER" appears and the auto off function
after protection generating is disabled.
Releasing method:
Press the [ ] button to turn the power off .
1
DCAC MIC TEST MODE
The auto calibration microphone input can be outputted from the
speaker.
Note: It is necessary to connect speakers to this unit.
Procedure:
1. While pressing the [MUSIC] and [DIMMER] buttons, press
the [ ] button to turn the power on.
1
2. The message "MIC" appears.
3. Check that sound which is inputted from microphone is out-
putted from the speaker.
Releasing method:
Press the [ ] button to turn the power off .
1
] counts down
1
SYS SET