Setting Up A Wireless (Wi-Fi) Network Connection - Pitney Bowes SendPro C Lite Operator's Manual

Connectivity information
Static
1. Select Static.
2. Contact your internal IT department to record the values you will need to enter for your device. The
values needed are the IP Address, Netmask, Gateway and DNS Address.
3. Enter the values you recorded in step 2 for the IP Address, Netmask, Gateway, and DNS
Address in the corresponding fields.
4. Tap Connect.
5. If it fails to connect, remove the network cable from the back of the device.
6. Tap the Connect button. Wait for the attempted connection to fail.
7. Plug the network cable back in.
8. Delete the values in the IP Address, Netmask, Gateway, and DNS Address fields.
9. Enter the IP Address, Netmask, Gateway, and DNS Address that you recorded in step 2.
10. Tap Connect.
NOTE: If your device's model number is 8H00 or 9H00 it will remember the Static IP information
even if you switch back to DHCP and then back again. This information includes IP Address,
Netmask, Gateway and DNS Address as well as the proxy information.

Setting up a wireless (Wi-Fi) network connection

You can connect your SendPro C Lite, SendPro C, SendPro+ device via a wireless network connection.
You can also connect your device to your mobile phone's hotspot, should the need arise.
1. Tap Settings on the toolbar.
2. Tap Wi-Fi in the Device & Network section.
3. Choose your Wi-Fi network from the list. Tap Add Network if your Wi-Fi network does not
appear.
4. Enter your Wi-Fi password and identity.
Tip: Use the show password option to make sure that you enter your password correctly.
Pitney Bowes Operator Guide February 2021 47