Icom IC-756PRO Alignment Procedure page 11

Receiver
- Set radio to follows
- Frequency:
- P AMP:
- Mode:
- Shift:
- Filter
- Connect RF signal generator to ANT connector
- Connect SINARDER to external SP Jack
- Apply 14.1015MHz signals to ANT connector
- Adjust L513, L721, L722 and L943 for maximum audio output
- Set radio to follows
- Dual watch:
- P AMP:
- Mode:
- Shift:
- Filter
- Set Balance controller to SUB Maximum
- Set sub frequency to 14.100000MHz
- Apply 14.1000MHz signals to ANT connector
- Adjust L613 for maximum RX sensitivity
Mixer balance
- Set radio to follows
- Main Frequency: 0.03000000MHz
- Sub Frequency: 0.03000000MHz
- Connect AF audio meter to external SP jack
- Apply no signals to ANT connector
- Set balance controller to MAIN maximum
- Adjust R516 for minimum audio output
- Set balance controller to Sub maximum
- Adjust R616 for minimum audio output
14.1015MHz
ON
USB
0
2.4KHz
ON
ON
USB
0
2.4KHz