Table of Contents
Advertisement
Installing the
Multiplexer in a
Mainframe
1
Set the extraction levers out.
Extraction
Levers
4
Tighten the top and bottom screws
to secure the multiplexer to the
mainframe.
NOTE: The extraction levers will not
seat the backplane connectors on older
VXIbus mainframes. You must manually
seat the connectors by pushing in the
module until the module's front panel is
flush with the front of the mainframe. The
extraction levers may be used to guide or
remove the multiplexer.
To remove the multiplexer from the mainframe,
reverse the procedure.
Figure 1-7. Installing the Multiplexer Module in a VXIbus Mainframe
18 Getting Started
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The E1476A can be installed in any slot (except slot 0) in a C-Size VXIbus
mainframe. See Figure 1-7 for steps to install the multiplexer in a mainframe.
2
Slide the E1476A into any slot
(except slot 0) until the backplane
connectors touch.
3
Seat the E1476A into
the mainframe by pushing
in the extraction levers.
Chapter 1
Advertisement
Table of Contents
