Recalling and Saving States
Saving States
Recalling States
Chapter 2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
This section contains information about saving and recalling multiplexer
states. The "SWITCHBOX" driver can store up to 10 states.
The
6$9 QXPHULFBVWDWH! command saves the current instrument state.
The state number (0-9) is specified in the QXPHULFBVWDWH parameter. The
following settings are saved:
•
Channel Relay State (channels 00 through 63 open or closed)
•
Control Relay States (channels 90 through 94 open or closed)
•
$50&281W
•
75,*JHU6285FH
•
2873XW>67$7H@
•
,1,7LDWH&217LQXRXV
•
>5287H@6&$102'(
•
>5287H@6&$13257
The
5&/ QXPHULFBVWDWH! command recalls a previously saved state.
Enter the number (0-9) in the QXPHULFBVWDWH parameter of the desired saved
state. If
6$9 was not previously executed using the selected number, the
multiplexer will configure to the reset values (see Table 2-1).
NOTE
Scan lists are not saved when a state is saved. You must re-enter the
scan list after recalling a state.
Switchbox Applications 55