Manual Operation - Dovre VINTAGE 35GA Installation Instructions And Operating Manual

09-20020-243
3. Press
(small flame) to set the minutes.
P2 ON time setting
1. Briefly press SET to go to P2 OFF time setting.
P2 (sun) appears and the time setting flashes.
2. See instructions ''P1 ON time setting''.
P2 OFF time setting
1. Briefly press SET to go to P2 OFF time setting.
P2 (moon) appears and the time setting flashes.
2. See instructions ''P1 OFF time setting''.
Timers P1 and P2 are now programmed. Press OFF.
The handset will automatically save your changes.

Manual operation

Manual operation of the stove is only possible if the
MAN button is used, see the following figure.
26
1
2
3
4
1 Piezo ignition
2 On/off switch (option)
3 Eight-wire-receiver-contact
4 Microswitch
5 Piezo ignition connection (2.8x0.8mm)
6 Manual button in MAN position
7 Manual pilot regulator
8 Main valve button in OFF position
Access to the pilot is only required for igniting
with a match.
Do not exert excessive force when turning the
main valve button. The button has a slip-action
clutch that clicks until the final stops are rea-
ched. This enables manual programming of the
flame height and the pilot standby position.
Read the safety information before continuing.
1. Turn the main valve button (8) to the OFF position,
completely clockwise
2. Turn the MANUAL button (6) to the MAN position,
completely clockwise
A manual pilot regulator and Piezo ignition
(option) are accessible when the MAN button
is in the MAN position.
3. Wait five minutes until the stove is free of gas.
Subject to change because of technical improvements
5
6
7
8
09-20020-244
.
.