Troubleshooting; Troubleshooting The Brushcutter And Battery - Stihl FSA 130 R Instruction Manual

English

18 Troubleshooting

18.1 Troubleshooting the Brushcutter and Battery

Fault LEDs on the
battery
The brushcutter does 1 LED flashing
not start when green.
switched on.
1 LED emits red
light.
3 LEDs flash red.
3 LEDs light
up red.
4 LEDs
flashing red.
The brushcutter cuts 3 LEDs light
out during operation. up red.
62
Cause
State of charge of the
battery is too low.
The battery is too warm or
too cold.
The brushcutter has a
malfunction.
The brushcutter is too hot. ► Pull the connecting cable plug out of the socket.
There is a fault in the
battery.
No electrical contact
between brushcutter and
battery.
The brushcutter or battery
is damp.
The brushcutter is too hot. ► Pull the connecting cable plug out of the socket.
Remedy
► Recharge the battery fully as described in the User
Manual for the STIHL AL 101, 300, 500 chargers.
► Pull the connecting cable plug out of the socket.
► Allow the battery to cool down or warm up.
► Pull connecting cable plug out of the socket and
plug in again.
► Switch on the brushcutter.
► If 3 LEDs continue to flash red: Do not use your
brushcutter and contact your STIHL dealer for
assistance.
► Allow the brushcutter to cool down.
► Pull connecting cable plug out of the socket and
plug in again.
► Switch on the brushcutter.
► If 4 LEDs continue to flash red: Do not use the
battery and contact your STIHL dealer for
assistance.
► Pull connecting cable plug out of the socket and
plug in again.
► If the brushcutter still does not start when switched
on: Clean the contacts of the connecting cable as
described in the STIHL AR battery's user manual
or in the user manual for the "AP belt bag with
connecting cable".
► Allow the brushcutter or battery to dry.
► Allow the brushcutter to cool down.
18 Troubleshooting
0458-725-9621-B