Factory Default Settings; Osd Security - ATEN CS-128A User Manual

Factory Default Settings

The factory default settings are as follows:
Setting
Display Duration
Display Mode
Scan Duration

OSD Security

In order to prevent unauthorized access to the computers, the OSD provides a
password security feature. If a password has been set, the OSD will request that
the user specify it before allowing entry. To set a password:
1. Press [F6] to bring up the setup configuration menu.
2. Move the highlight bar to Set Password, then press [Enter].
3. Key in the new password, then press [Enter].
The password may be up to 8 characters long, and can consist of any combi-
nation of letters and numbers (A - Z, 0 - 9).
4. Key in the new password again, in order to confirm that it is correct then
press [Enter].
If the two entries match, the new password is accepted and the screen dis-
plays the following message:
SET PASSWORD OK
If the entries do not match, the screen displays the message:
PASSWORD NOT MATCH
in which case you must start again from the beginning.
Note: To modify or delete a previous password, access the Password
function as in Step 1, above, then use the backspace or delete key to
erase the individual letters or numbers.
22
Always On
The Port Number plus the Port Name
3 Seconds
Default
CS-128A User Manual