Table of Contents
Advertisement
USER GUIDE
7
FEATURES
The LCD projector has a variety of different features implemented. This
chapter explains each feature in detail.
7.1.1
INTELLIGENT SAFECOOL SYSTEM
The fan operates as long as the LCD projector is switched on. This
ensures a continuous protection against high temperature inside the
projector. The cooling system is designed to minimize stray light and
noise.
7.1.2
MOTORIZED LAMP CHANGER
The projector is equipped with two 400W halogen lamps. If one lamp fails
during a presentation, the spare lamp can be shifted in position and
switched on. Press the LAMP CHANGER button on the control panel to
change lamp. This ensures continuous operation during a presentation.
A LED on the control panel lights when the spare lamp is in use, indicating
that the defective lamp should be replaced.
Always replace the defective lamp as soon as the projector has
cooled down after use
To avoid burns, do not open the rear door to replace a defective
lamp until the unit has cooled down after operation. The interior
of the projector is heated during use.
7.1.3
SET-UP MEMORY
The user controlled set-up, that usually is done when the projector is
connected to a new computer, is automatically memorized for future use.
The set-up information is stored in a non-volatile memory approximately 5
seconds after the last key is pressed.
The memory can store 40 different sources/modes. Several sources are
predefined, while the remaining are available for customer set-up of
sources. See the Technical Data section for compatibility.
Custom sources are stored only if their sync pattern differs from any of the
previous selections. The projector automatically selects a new memory
location.
18
LCD PROJECTOR
Advertisement
Table of Contents
