Table of Contents
Advertisement
CSX-V58MP
Connections
Cautions
• This unit is designed for negative earth 12 V
DC operation only.
• Do not get the wires under a screw, or caught
in moving parts (e.g., seat railing).
• Before making connections, turn the car
ignition off to avoid short circuits.
• Read carefully the Installation/Connections
manual supplied with both this unit and
optional units, before making connections.
• Be sure to insulate any loose unconnected
wires with electrical tape for safety.
• For your safety, the monitor connected to the
VIDEO OUT of this unit can only be viewed
when the car is stopped and the parking brake
is applied.
Be sure to connect the parking brake cord 8
(light green) to the car's parking brake switch
cord.
Parts Iist (1)
The numbers in the list are keyed to those in the
instructions.
The supplied tool qs is necessary for removing
the unit. For details, refer to "Removing the
unit" in the supplied operating instructions.
Caution
Handle the bracket 1 carefully to avoid injuring
your fingers.
6
Connection example (2)
This unit must be connected to an optional Sony
master unit with BUS control functions, such as
Media Center/Receiver XAV-7W.
To use the unit with:
— an optional Media Center/Receiver XAV-7W
connected (A).
— an optional monitor and an optional Sony
BUS compatible master unit connected (B).
Connection diagram (3)
Connecting the parking brake
cord (4)
Be sure to connect the parking brake cord 8
(light green) to the car's parking brake switch
cord, whose mounting position depends on your
car. Please consult your car dealer or your
nearest Sony dealer for further details.
Using the pressure terminal
Clasp the end of the parking brake cord 8 (light
green) and the car's parking brake switch cord
with the pressure terminal 7.
Note
If the car's parking brake switch cord is too thin,
connect the parking brake cord 8 (light green) to
the car's parking brake switch cord directly without
using the pressure terminal 7 .
Advertisement
Table of Contents
