Garmin Aera 760 Pilot's Manual page 206

Appendix D
NOTE: Readjust the position of the aera 760 to provide the best view of the
display screen as lighting conditions change.
Attaching the yoke mount to the yoke shaft or control arm:
1) Open the clamp by turning the Clamp Adjustment Knob until it can be
easily placed over the yoke shaft or control arm. Install the yoke mount as
far from the panel as is practical.
2) When in place, tighten the Clamp Adjustment Knob to secure the yoke
mount to the yoke shaft or control arm.
3) Loosen the Cradle Adjustment Knob, then orient the aera 760 as desired.
4) Tighten the Cradle Adjustment Knob to hold the aera 760 in place.
5) Connect power/data cables.
Attaching the aera 760 to the yoke mount:
1) Fit the bottom of the aera 760 into the cradle.
2) Tilt the aera 760 back until it snaps into place.
Removing the aera 760 from the yoke mount:
1) Press the Release Button on the side of the mount to release the aera 760.
2) Lift out the aera 760.
190
Garmin aera 760 Pilot's Guide 190-02674-00 Rev. B