Indesit HOTPOINT HVL200UK Service Information page 6

DRAINAGE CONNECTIONS
A. Connect the drain hose, without bending it,
to a draining duct or a wall drain fixed at a
height between 65 and 100 cm from the
floor.
65 - 100 cm
B. Alternatively, place it over the edge of a
basin, sink or tub, fastening the hose
supplied to the tap.
The free end of the hose should not be
under water.
! We advise against the use of hose
extensions. In case of absolute need, the
extension must have the same diameter as
the original hose and must not exceed
150cm in length.
Electrical Connections
Before plugging the appliance into the
mains socket, make sure that:
- the socket is earthed and in compliance
with the applicable law.
- the socket is able to sustain the
appliance's maximum power load.
- the supply voltage is included within the
values indicated in the Specifications page.
- the socket is compatible with the washing
machines plug. If this is not the case,
replace the socket or the plug.
Location
! The washing machine should not be
installed in an outdoor environment, not
even when the area is sheltered, because it
may be very dangerous to leave it exposed
to rain and thunderstorms.
! When the washing machine is installed, the
mains socket must be within easy reach.
! Do not use extensions or multiple sockets.
! The power supply cable must never be bent
or dangerously compressed.
! The power supply cable must only be
replaced by an authorised serviceman.
WARNING!
The company denies all liability if and when
these warnings are not respected.
The first wash cycle
Once the appliance has been installed and
before you use it for the first time, run a
wash cycle without detergent and no
laundry, setting the 'B' programme without a
pre-wash cycle.
6