Indesit HOTPOINT HVL200UK Service Information page 20

F. Detergent Drawer
1. Open the dispenser drawer fully, gently lift slightly on the right hand
side, grip draw front and pull to remove dispenser.
G. Dispenser Hopper
1. Remove the top cover (A).
2. Remove the drawer (F).
3. Remove the 2 screws securing the dispenser to the control panel.
4. Remove the valve support screw and valve wiring.
5. Unhook the dispenser outlet hose from the dispenser.
6. Remove the valve support plate screws from back panel
7. Lift the dispenser hopper clear
H. Valve Assembly
1. Remove the top cover (A).
2. Remove the dispenser hopper (G).
3. Remove the screws securing the valve to the dispenser.
4. Remove the valve ensuring the seals are replaced in the hopper.
I. Door Seal Retainer to Outer Case
1. The door seal is fixed to the cabinet front panel by a wire clamp and a small spring.
2. The spring is usually at the bottom of the door.
3. Carefully attach a small screwdriver to one of the ears of the spring, by stretching the spring the
wire can be removed.
J. Door Seal
1. Remove the washing machine top cover (A).
2. Remove the outer wire clamp attaching the seal to the cabinet.
3. Release the door seal from the cabinet.
4. Remove the door seal from the tank front. The seal is fixed to the tank front by a sprung ring.
K. Door
1. Open the door.
2. Unscrew the 4 x 8 mm bolts securing the door to the cabinet front.
3. Support the door whilst removing the securing bolts.
L. Door Interlock Assembly
1. Remove the top cover (A).
2. Remove the 2 x T15 torx screws, release the wiring in the cabinet clip and disconnect the wiring
from the interlock.
20