Indesit HOTPOINT HVL200UK Service Information page 21

M. Belt & Pulley Removal
1. Remove the back panel (B).
2. Using the Pulley Locking Tool (Part No. 560114) and T40 Torx Bit (Part No. 5500048), remove
the pulley fixing screw and ease the pulley away from the shaft.
N. Mains Cable/ Suppressor
1. Remove the top cover (A).
2. Disconnect the mains loom plug connector from the suppressor.
3. Remove the earthing screw securing the suppressor and mains cable unit to the cabinet. Lift the
unit upwards and withdraw from the cabinet.
O. Tank / Drum Assembly
1. Remove the top cover (A), back panel (B), mains cable / suppressor (N), motor (Q).
2. Remove the 4 screws securing the drain pump to the front panel.
3. Disconnect the wiring attached to the outer drum via cable clips.
4. Unclip the valve hoses and electrical connections.
5. Insert slide, (Part No. 5600155) inside the cabinet at the rear of the drum.
6. Using suitable protection lay the appliance on its back.
7. Remove the 2 x 10 mm nuts securing the shock absorbers to the base of the cabinet.
8. Remove the tank / pump hose.
9. Remove the 4 screws securing the cabinet support bar.
10. Carefully slide the outer drum clear protecting any wiring.
P. Front Counterweight
1. Remove the drum assembly (O).
2. Remove 3 securing bolts, (1 x 10 mm bolt and 2 x T40 Torx bolt).
Q. Motor
1. Remove the six screws securing back panel (B) to gain access to the belt.
2. Release the belt from the motor pulley.
3. Remove 2 x 10 mm bolts securing the motor to tank. The motor must be supported when
removing the bolts.
4. Carefully lift motor clear
R. Shock Absorbers
1. Using suitable protection lean the appliance onto one side.
2. Remove the 10 mm nut securing the shock absorber to the cabinet (note hole location prior to
removal).
3. Push the shock absorber on the rod until it comes out of the cabinet.
4. Remove the plastic securing bolt from the drum and remove the shock absorber from the cabinet.
S. Drain Pump
1. Remove the plinth at the bottom of the appliance.
2. Using suitable protection, tilt the machine backwards and support.
3. Remove the 4 pump fixing screws and disconnect the hoses and wiring.
21