Indesit HOTPOINT HVL200UK Service Information page 22

T. Power Module
Service Modules are not supplied with an Eeprom fitted. Order and fit the correct item
before fitting the module to the machine.
1. Remove the back panel (B).
2. Remove the T15 torx screw and the hardware key cover securing the module support to the
cabinet.
3. Disconnect the wiring connections, note the plug positions
4. Lift the module and support clear.
NOTE: - To remove or fit the Eeprom,
use the Eeprom Removal Tool (Part
No. C00066292).
On the original control board, the
Eeprom is soldered to the board and
cannot be removed. When replacing
the board an Eeprom will also be
required.
When fitted it MUST be inserted the
correct way round, with the notch on
the Eeprom at the same end as the
notch on the socket.
Three variations of Eeprom can be found
or used on Power Boards:
C00066292
22
EEPROM
Notch this end