Y
S
OUR
WITCH
You can configure IP address information for your
switch, enabling you to manage it over the network.
It is important that you note down this information as
you may need to refer to it when managing the
switch again. Use this page to note down your
settings.
If you want to initialize the switch, the IP address
settings are retained to allow you to continue
managing the switch. If you want to return the switch
to its default address settings, you must enter them
manually.
For information on configuring the IP address settings
using the:
Web interface — refer to
Addresses"
on page 4-11.
Command Line Interface — refer to
Configuration"
on page 5-7.
A
DDRESSES
"Management
"Setting the IP
Parameter
Default
Device
Switch 140M
name
Location
(blank)
Contact
(blank)
IP address
0.0.0.0
Subnet
0.0.0.0
mask
Serial Line
192.168.101.1
IP address
Subnet
255.255.255.0
mask
Router
0.0.0.0
IP address
Your setting