Table of Contents
Advertisement
Bluetooth function
■
The terminal cannot be connected to a
Bluetooth device/A Bluetooth device
cannot be found by search.
Allow Bluetooth device (commercially
･
available) to be detectable and then make
pairing with the device on the terminal. If
you want to cancel a paired device and
then make the pair setting again, cancel
the pair settings on both the terminal and
the Bluetooth device (commercially
available).
P.201
→
Calls cannot be made from the terminal
connecting to external device such as car
navigation or handsfree device.
If calls are made several times when the
･
other party does not answer or is out of
service, the call to this number may be
disabled. In this case, turn terminal off and
on.
External device connection
■
An external device connected using USB
cable A to C etc. is not recognized.
Reconnect the external device.
･
However, some devices may not be
detected.
Map/GPS
■
Cannot set AUTO-GPS service
information.
Check if the battery level is low and AUTO-
･
GPS function stops.
If AUTO-GPS stops due to "Low-power
operation settings", AUTO-GPS service
information cannot be set. In this case, set
"Low-power operation settings" to "Not
suspend" or charge the battery.
P.189
Check if "AUTO-GPS operation settings" is
･
marked.
P.189
→
Error messages
No service
●
The terminal is out of service area, or the
･
received signal is too weak. Move to a
location where radio signal can be
reached.
The docomo nano UIM card is not
･
working properly.
Removing and inserting docomo nano
UIM card may solve the problem.
If the problem persists, contact "Repairs
(Inquiries/Request)" on the last page of
this manual (in Japanese only).
P.37 ,
→
Appendix/Index
222
Advertisement
Table of Contents
