Touch Sensor Tone; Manual Clock Adjustment; Synchronize Clock; Dsi (Disabled System Indicator) - Kenwood KDC-W534 Instruction Manual

Menu system
In Standby mode

Touch Sensor Tone

Setting the operation check sound (beep sound)
ON/OFF.
Display Setting
"BEEP ON" Beep is heard.
"BEEP OFF" Beep canceled.
In Standby mode

Manual Clock Adjustment

• You can do this adjustment when the <Synchronize
Clock> (page 22) is set as OFF.
1
Select Clock Adjustment mode
Push the Control knob towards [FM] or [AM].
Select the "CLK ADJ" display.
2
Enter Clock Adjust mode
Press the Control knob for at least 1 second.
The clock display blinks.
3
Adjust the hours
Push the Control knob towards [FM] or [AM].
Adjust the minutes
Push the Control knob towards [4] or
[¢].
4
Exit Clock adjustment mode
Press the [MENU] button.
Function of the KDC-W534
In Standby mode

Synchronize Clock

Synchronizing the RDS station time data and this
unit's clock.
Display Setting
"SYNC ON" Synchronizes the time.
"SYNC OFF" Adjust the time manually.
• It takes 3 to 4 minutes to synchronize the clock.
22
|
English

DSI (Disabled System Indicator)

A red indicator will blink on the unit after the
faceplate is removed, warning potential thieves.
Display Setting
"DSI ON" LED flashes.
"DSI OFF" LED OFF.
In Standby mode

Selectable Illumination

Selecting the button illumination color as green
or red.
Display Setting
"KEY RED" The illumination color is red.
"KEY GRN" The illumination color is green.

Display Illumination Control

This function turns off the display when you
perform no operation for 5 seconds. This function
is effective when you are driving at night.
Display Setting
"DISP ON" Keeps the display on.
"DISP OFF" Turns off the display when you perform no
operation for 5 seconds.
• Set the Display Illumination Control when the
<Demonstration mode Setting> (page 25) is set to
OFF.
• When the display is off, pressing any key will turn on
the display.
• When the display is off, you cannot perform any
operation except for the following:
• Volume
• Attenuator
• Selecting the source
• Ejecting the disc
• Turning off the power
• Dimmer Control
• During function control, such as the Menu System, the
display stays on.