Kenwood KDC-BT41U Instruction Manual page 34

Symptom
Correct characters are not displayed
(e.g. album name).
Bluetooth
Symptom
The hands-free talk volume is low. The hands-free talk volume can be adjusted independently. Adjust it during hands-free talk.
No beep is heard at reception of an
incoming call.
Voice is not recognized.
"NO NUMBER" appears.
"NO DATA" appears.
"NO ENTRY" appears.
"HF DISCONCT" appears.
"HF ERROR 07" appears.
"HF ERROR 68" appears.
"UNKNOWN" appears.
"DEVICE FULL" appears.
"PIN CODE NG" appears.
"CONNECT NG" appears.
"PAIRING NG" appears.
"NO MARCHING" appears.
"TOO SOFT" appears.
"TOO LOUD" appears.
"TOO LONG" appears.
"NO PHONEBOOK" appears.
"NO MESSAGE" appears.
"NO RECORD" appears.
"MEMORY FULL" appears.
"NO VOICE" appears.
The sound from the Bluetooth
audio player is discontinuous.
34
English
This unit can only display letters (upper case), numbers, and a limited number of symbols.
[MIC GAIN], [NR LEVEL] and [EC LEVEL] of <Bluetooth Setup> (page 22).
No beep is heard depending on the type of your cell-phone. The [CALL BEEP] of <Bluetooth
Setup> (page 22) is set ON.
■
The vehicle window is open. If the surrounding noise is large, voice cannot be recognized
properly. Close the vehicle windows to reduce noise.
■
Small voice. If voice is too small, it cannot be recognized properly. Speak into the microphone
a little more loudly and naturally.
■
The person uttering the voice tag is not the one who registered the it. Only the voice of the
person who registered the voice tag can be recognized.
The calling party does not notify a caller ID. / There is no phone number data.
There is no outgoing call list. / There is no incoming call list. / There is no missed call list. / There
is no phone book list.
The cell-phone has not been registered (pairing).
The unit cannot communicate with the cell-phone.
The memory cannot be accessed. Turn off the power and on again. If this message still appears,
press the reset button on the control unit.
The unit cannot communicate with the cell-phone. Turn off the power and on again. If this
message still appears, press the reset button on the control unit.
The Bluetooth device cannot be detected.
5 Bluetooth device have already been registered. No more Bluetooth device cannot be
registered.
The PIN code is wrong.
The unit cannot be connected to the device.
Pairing error.
The voice tag is wrong. Voice cannot be recognized because of an unregistered voice tag, etc.
Voice is too small and cannot be recognized.
Voice is too large to be recognized.
The word or utterance is too long to be recognized.
Data is not contained in the phone book.
No short message in In Box.
The voice tag is not registered in the phone book.
The number of voice tags reaches the maximum number to be registered in the phone book.
No call.
■
Another Bluetooth device is affecting the Bluetooth communication. Turn off another
Bluetooth device. Move another Bluetooth device away from this unit.
■ Another Bluetooth device or profile is used for communication. The downloading of the
Phone book or the SMS disconnects the sound.
Remedy/Cause
Remedy/Cause