Registering Bluetooth Device (Pairing); Selecting The Bluetooth Device - Kenwood KDC-BT41U Instruction Manual

Registering Bluetooth Device
(Pairing)
Registering from Bluetooth devices
Press SRC to turn on the power.
1
Start registering this unit by operating
2
the Bluetooth device.
By operating the Bluetooth device, register
the hands-free unit (pairing). Select
"KENWOOD BT CD/R-3P1" from the list of
connected units.
Input the PIN code ("0000") in the
3
Bluetooth device.
Check that registration is complete on the
Bluetooth device. PIN code is set to "0000"
as the default. You can change this code.
Refer to [PIN CODE EDIT]/ [PIN EDIT]
under <Bluetooth Setup> (page 22).
By operating the Bluetooth device, start
4
hands-free connection.
Registering from this unit
Press to enter Bluetooth mode.
1
Turn the volume knob to select
2
[SETTINGS], then press to enter.
Turn the volume knob to select
3
[PAIRING], then press to enter.
Turn the volume knob to select [DEVICE
4
SEARCH]/ [DVC SEARCH], then press to
enter.
Press the volume knob to search for the
5
Bluetooth device.
When search is completed, "FINISHED" is
displayed.
Turn the volume knob to select a
6
Bluetooth device name, press to confirm.
Input the PIN code
7
■
Turn the volume knob to select the
number.
To move to the next digit, press ¢.
■
To delete the last digit, press 4.
■
Press the volume knob to transmit the
8
PIN code.
If "PAIRING OK" is displayed, registration is
completed. If the error message appears
even though the PIN code is correct, try
Registering Special Bluetooth device.
20
English
9 Hold to finish the procedure.
■
To exit Bluetooth mode, press
■
If there are 5 or more Bluetooth devices
registered, you cannot register a new
Bluetooth device.
Registering Special Bluetooth device
Press to enter Bluetooth mode.
1
Turn the volume knob to select
2
[SETTINGS], then press to enter.
Turn the volume knob to select
3
[PAIRING], then press to enter.
4 Turn the volume knob to select [S-DVC
SELECT]/ [S-DVC SEL], then press to
enter.
Turn the volume knob to select a device
5
name, press to confirm.
6 Go through the procedure step 4
of <Registering from this unit> and
complete the registration (pairing).
■
If the device name is not in the list, select
"OTHER PHONE".

Selecting the Bluetooth Device

1 Press to enter Bluetooth mode.
Turn the volume knob to select
2
[SETTINGS], then press to enter.
Turn the volume knob to select
3
[PAIRING], then press to enter.
4 Turn the volume knob to select [PHONE
SELECT]/ [PHONE SEL], then press to
enter.
Turn the volume knob to select a
5
Bluetooth device name.
Press the volume knob to set up the
6
Bluetooth device.
■
"✱(Device name)": The selected Bluetooth
device is busy.
■
"-(Device name)": The selected Bluetooth
device is on standby.
■
" (Device name)": The Bluetooth device is
deselected.
■
If a cell-phone is already selected,
deselect it, and then select a different
one.
Hold to finish the procedure.
7
■
To exit Bluetooth mode, press
.
.