Operating A Computer Using The Remote Control; Placement - Toshiba TDP-T99U Owner's Manual

Operating a computer using the remote control

A computer can be operated using the projector's remote control. This function is available
®
on any computer with the Windows 98/98SE, Windows
®
dows XP OS, that is equipped with a USB port which can support USB1.1 (The mouse
remote control receiver is also supported on OS 9 or OS X for the Macintosh). However,
please note that Toshiba does not guarantee the operation of all computers.
1 Connecting a computer
Connect the mouse remote control receiver (supplied) to a computer.
To USB port
Mouse remote control receiver
2 Operating a computer
Operate remote control's buttons towards the mouse remote control receiver.
● Moving the mouse pointer
Press the mouse control button in the direction you wish the mouse pointer to move,
then press.
● To left click
Press the L-CLICK button.
● To right click
Press the R-CLICK button.
● To drag and drop
Holding down the L-CLICK button, move the mouse control button until the mouse
pointer is over the desired location, then release the L-CLICK button.
● Using the computer's page up [ ↑ ] and down [ ↓ ] function
Press the PAGE+ and PAGE- buttons to switch PowerPoint
Remote Control Front
Mouse control
PAGE –
R-CLICK
® ®
Me, Windows 2000, or Win-
The remote control may fail to operate
if the mouse remote control receiver is
exposed to bright sunlight or
fluorescent lighting.
In such a case, change position or
direction of the mouse remote control
receiver and retry.
®
slides.
Remote Control Rear
L-CLICK
PAGE +
20

Placement

Placement Styles
As shown in the figures below, this device can be placed in 4 different styles.
The factory setting is "floor-mounted front projection." Set the [Projection mode] in the
Default setting menu p.40 , in accordance with your needs.
Floor-mounted front projection
Ceiling-mounted front projection
WARNING
• Always obey the instructions listed in IMPORTANT SAFETY INSTRUCTIONS when placing the unit.
Attempting to clean/replace the lamp at a high site by yourself may cause you to drop down, thus
resulting in injury.
• If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so. Mounting the
projector on a ceiling requires special ceiling brackets (sold separately) and specialized knowledge.
Improper mounting could cause the projector to fall, resulting in an accident.
• If the projector is ceiling-mounted, install the breaker for turning off the power in case of anomaly. Let
everyone involved with the use of the projector know that fact.
Projection Distance and Size
Use the figures, tables, and formulas below to determine the projection size and projection
distance. (Projection sizes are approximate values for full-size picture with no keystone
adjustment.)
As seen from above
Screen
90°
As seen from the side
Lens center
90°
a
a is the distance (m) between the lens and the screen, and
corresponds to a range of 1.07 m to 11.09 m.
Floor-mounted rear projection
Ceiling-mounted rear projection
projection size (inches) – 1.0437
a (min length) =
26.957
projection size (inches) – 0.6246
a (max length) =
16.749
projection distance a (m)
projection
min length max length
size (inches)
(zooming max) (zooming min)
30 1.07 1.75
40 1.45 2.35
60 2.19 3.55
80 2.93 4.74
100 3.67 5.93
150 5.53 8.92
200 7.38
250 9.24
300 11.09
21
–
–
–